Be Still, My Metal Pot

|

I've been incompetently building a steam distillation rig this last week or so. I started with this pile of stuff, some scrounged from neighbors or junk piles, some bought at thrift stores. The squirrel was Goldie's contribution.

Still materials

First up was drilling a hole in the pot lid, which Noel did for me with a fine step bit. I won't say how I attempted the job but I will say it involved that ball-peen hammer there and made quite a racket if no progress whatsoever.

The hole in the lid allowed me to put a compression fitting there to hold the condenser coil in place. Then I could move on to making a rack to go inside the pot and hold my material to be steamed above the water bath.

So we have a weird metal plate thing from the Sally Am, some long bolts, some washers, and some high-temperature adhesive intended for making copper coloured gaskets. Good stuff.

Material rack pieces

I glued it all together like this and with any luck, tomorrow morning it will be a usable rack that sits just far enough up in the pot to stay out of the water bath.

Glued-up material rack

This afternoon's fun was making a water bath for the condenser. I used the old bucket from the chicken waterers, and spent a good half hour wrestling with the copper tubing to get it in there. Some aquarium silicone around the hole for the drip-out, and 24 hours to sit and ponder its sins, and we will be ready for a test run.

Assembled still

Now to decide what to distill first. I'm thinking roses, since we're sort of all overloaded with roses out front right now.

About this Entry

This page contains a single entry by Ayse published on May 30, 2009 6:27 PM.

Of Spinning and Wheels was the previous entry in this blog.

Spinning Day at the Winery is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Pages

Powered by Movable Type 4.12